Siemens SINUMERIK 840D sl Operating Manual page 571

Parameters
FR
Fixed
stop
Function, complete
Withdraw blank
F
Cutting-off
cycle
Function, complete
Zero offset
ZW
ZV
Parameters
Function, gripping
Coordinate
system
XP
ZP
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Description
Reduced feedrate
Travel to fixed stop
Yes
•
The counterspindle stops at a defined distance away from transfer position
Z1 and then traverses with a defined feedrate up to the fixed stop.
No
•
The counterspindle traverses to the transfer position Z1.
Withdrawing
Withdraw complete blank:
Yes
•
No
•
Feedrate
Cutting-off cycle in the following block
Yes
•
No
•
Rear face
Zero offset in which the coordinate system, which was shifted according to ZW
and by ZV as well as mirrored in Z, must be saved:
Basic reference
•
G54
•
G55
•
G56
•
G57
•
...
•
Machining position for special axis (abs.); machine coordinate system
Offset Z = 0
Workpiece zero is offset in Z direction (inc, the sign is also evaluated)
Description
Teaching in the park position and angular offset is possible
MCS
•
The park position is specified in the machine coordinate system. Teaching in
the park position and angular offset is only possible in the machine coordinate
system.
WCS
•
The park position is specified in the workpiece coordinate system.
Park position of tool in X direction (abs)
Park position of tool in Z direction (abs)
Multi-channel machining (only 840D sl)
9.2 Multi-channel support (only 840D sl)
Unit
mm/rev
mm/min
mm
mm
Unit
mm
mm
571