Siemens SINUMERIK 840D sl Operating Manual page 373

Parameter Description
UZ Finishing allowance in Z – (only for ∇)
DI For zero: Continuous cut - (only for ∇)
BL Blank description (only for ∇)
•
•
•
XD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
•
•
ZD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
•
•
Allowance Allowance for pre-finishing - (only for ∇∇∇)
•
•
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
•
•
Set machining area Set machining area limits
limits
•
•
with limited machining area only, yes:
XA 1. Limit XA ∅
XB 2. Limit XB ∅ (abs) or 2nd limit referred to XA (inc)
ZA 1. Limit ZA
ZB 2. Limit ZB (abs) or 2nd limit referred to ZA (inc)
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Cylinder (described using XD, ZD)
Allowance (XD and ZD on the finished part contour)
Contour (additional CYCLE62 call with blank contour – e.g. cast iron mold)
For blank description, cylinder
– Version, absolute:
Cylinder dimension ∅ (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
For blank description, allowance
Allowance on the CYCLE62 finished part contour (inc)
For blank description, cylinder
– Version, absolute:
Cylinder dimension (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
For blank description, allowance
– Allowance on the CYCLE62 finished part contour (inc)
Yes
U1 contour allowance
No
Positive value: Compensation allowance is kept
Negative value: Compensation allowance is removed in addition to finishing
allowance
Yes
No
Programming technology functions (cycles)
8.3 Contour turning
Unit
mm
mm
mm
mm
mm
mm
mm
373