Siemens SINUMERIK 840D sl Operating Manual page 391

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

The positions refer to the reference point:

Reference point X – (only for single position)

Reference point Y – (only for single position)

Reference point Z

(only for G code)

Face C: The positions refer to the reference point:

Reference point X or reference point length polar – (only for single position)

Reference point Y or reference point angle polar – (only for single position)

Reference point Z – (only for single position)

Face Y: The positions refer to the reference point:

Positioning angle for machining area – (only single position)

Reference point X or reference point length polar – (only for single position)

Reference point Y or reference point angle polar – (only for single position)

Reference point Z – (only for single position)

Peripheral surface C: The positions refer to the reference point:

Reference point Y or reference point angle polar – (only for single position)

Reference point Z – (only for single position)

Cylinder diameter ∅ – (only for single position)

Peripheral surface Y: The positions refer to the reference point:

Positioning angle for machining surface – (only for single position)

Reference point Y – (only for single position)

Reference point Z – (only for single position)

Reference point X – (only for single position)

Diameter of pocket

Pocket depth (abs) or depth relative to Z0/X0 (inc) – (only for ∇, ∇∇∇ and ∇∇∇ edge)

Maximum plane infeed

Maximum plane infeed as a percentage of the milling cutter diameter

- (only for ∇ and ∇∇∇)

Maximum depth infeed - (only for ∇, ∇∇∇ and ∇∇∇ edge)

Plane finishing allowance - (only for ∇, ∇∇∇ and ∇∇∇ edge)

Depth finishing allowance – (only for ∇ and ∇∇∇)

Operating Manual, 03/2013, 6FC5398-8CP40-3BA1

Programming technology functions (cycles)

Sinumerik 828d turning