Genie S-40 Operator's Manual page 45

Eight Edition • First Printing
Pipe Cradle Operation
1 Be sure the pipe cradle assembly and
installation instructions have been followed
properly and that the pipe cradles are secured
to the platform railings.
2 Place the load so that it rests in both pipe
cradles. The length of the load should be
parallel with the length of the platform.
3 Center the load in the pipe cradles.
4 Secure the load to each pipe cradle. Pass the
nylon strap over the load. Depress the buckle
and slide the strap through. Tighten the strap.
5 Gently push and pull on the load to make sure
the pipe cradles and load are secure.
6 Keep the load secured when the machine is
moving.
Tip-over hazard. The weight of the pipe cradle
assembly and the load in the pipe cradles will
reduce the rated platform capacity of the
machine and must be factored into the total
platform load.
Tip-over hazard. The weight of the pipe cradle
assembly and the load in the pipe cradles may
limit the maximum number of occupants in the
platform.
Maximum Pipe Cradle Capacity
All models
Pipe Cradle Assembly Weight
Part No. 1259838
Operating Instructions
Installation of Padding
1 Install the 2 pieces of padding on the platform
rails. Position the padding to protect the panels
from contact with the platform rails.
Check Engine Light (if equipped)
Machine Not Level Indicator Light
(if equipped)
After Each Use
1 Select a safe parking location—firm level
surface, clear of obstruction and traffic.
90.7 kg
2 Retract and lower the boom to the stowed
9.5 kg
position.
3 Rotate the turntable so that the boom is
between the non-steer wheels.
4 Turn the key switch to the off position and
remove the key to secure from unauthorized
use.
S-40 • S-45
Operator's Manual
Light on and engine stopped: Tag the
machine and remove from service.
Light on and engine still running:
Contact service personnel within
24 hours.
Light on indicates machine is not
level. The tilt alarm will be sounding
when this light is on. Move the
machine to a firm level surface.
43