Genie S-40 Operator's Manual page 44

Operator's Manual
Operating Instructions
Pipe Cradle Instructions
The pipe cradle assembly consists of 2 pipe
cradles positioned at either side of the platform
and mounted to the guardrails with U-bolts.
a strap
b U-bolts
c pipe cradle mount
d upper platform railing
e pipe cradle weldment
f middle platform railing
g flat washers
h nylock nuts
42
Observe and Obey:

Pipe cradles must be installed on the inside of
the platform.

Pipe cradles must not obstruct the platform
controls or the platform entrance.

The bottom of the pipe cradle tube must rest
on the platform floor.

Be sure the platform is level before installing a
pipe cradle.
Pipe Cradle Installation
1 Install a pipe cradle on each side of the
platform. Refer to the illustration on the left.
Make sure the bottom of the pipe cradle tube
rests on the platform floor.
2 Install two U-bolts from the outside of the
platform rails through each pipe cradle mount.
3 Secure each U-bolt with 2 washers and 2 nuts.
S-40 • S-45
Eight Edition • First Printing
Part No. 1259838