Genie S-40 Operator's Manual page 34

Operator's Manual
Inspections
Test Limited Drive Speed
43 Press down the foot switch.
44 Raise the boom to just above horizontal.
45 Slowly move the control handle to full drive
position.
Result: The maximum achievable drive speed
with the boom raised should not exceed 30 cm
per second.
46 Lower the boom to the stowed position.
47 Extend the boom 30 cm.
48 Slowly move the control handle to full drive
position.
Result: The maximum achievable drive speed
with the boom extended should not exceed
30 cm/s.
If the drive speed with the boom raised or
extended exceeds 30 cm/s, immediately tag and
remove the machine from service.
32
Test Emergency Controls
49 Shut off the engine.
50 Pull out the red Emergency Stop button to the
on position.
51 Press down the foot switch.
52 Simultaneously hold the emergency power
switch on and activate each function control
handle or toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate. Drive functions should not operate
with emergency power.
Test the Lift/Drive Select Function
53 Press down the foot switch.
54 Move the drive control handle off center and
activate a boom function toggle switch.
Result: No boom functions should operate.
The machine will move in the direction
indicated on the control panel.
Repair any malfunctions before operating the
machine.
S-40 • S-45
Eight Edition • First Printing
Part No. 1259838