17
Data Rate Calculations
To aid the calculation of data rate throughput the following plots of data rate throughput
verses link range have been produced for all the Canopy 150/300 Mb BH modulation modes
assuming the units are connected using Gigabit Ethernet.
To aggregate data rate capacity can be calculated using four key system parameters:
•
Receive modulation mode
•
Transmit modulation mode
•
Range Between the two wireless units
•
Wireless link mode (IP or TDM)
Using these parameters the receive and transmit data rates can be looked up using the plots
Figure 102 through Figure 114.
Issue 1.1 April 2006
Figure 102: BPSK 0.63 Single Payload
Figure 103: QPSK 0.63 Single Payload
Page 162