The cable should be assembled to the following instructions:
Step 1: Assemble gland on cable as shown
Step 2: Strip the outer insulation
Step 3: Arrange conductors as shown in
Step 4: Insert conductors and crimp
Figure 14 and cut to length
Figure 13: Completed ODU connector
Both ends of the ODU cable are terminated in the same way. The above procedure should be
repeated for the Canopy 150/300 PIDU end of the cable when the cable routing process is
complete.
Note: The Canopy 150/300 PIDU end of the cable does not employ a cable gland.
Issue 1.1 April 2006
Page 39