Telecoms Channel Selection This controls the selection of the telecoms interface standard
supported options or E1 and T1.
Channel A Line Code The line code setting of the telecoms interface. This must match the
setting of the device connected to this interface.
Channel B Line Code The line code setting of the telecoms interface. This must match the
setting of the device connected to this interface.
Cable Length This field is applicable to the T1 operating mode only. It configures the T1
transceiver to output a signal suitable for driving a cable of the specified length. This should
be set to reflect the length of cable between the wireless unit and the connected equipment.
8.3.4.4 Wireless Configuration
Step 2 of the installation wizard requires the installer to enter the wireless configuration
parameters.
Issue 1.1 April 2006
Figure 39: Telecoms Data Entry
Page 78