The unit will now reboot. The unit should now start up in normal mode but with the IP address
set to 169.254.1.1/2 and the Ethernet interface set to auto-negotiate and auto-MDI/MDIX.
Should the unit fail to start up the user should refer to section 10 "Fault Finding ".
9.3
Erase Configuration
To erase the unit's configuration the user should press the "Erase Configuration" button on
the "Recovery Options" page (Figure 74). The user will now be presented with a pop up box
asking them to confirm the action (Figure 80).
On confirmation the following page will be displayed (Figure 81). The user should now reboot
the unit by pressing the "Reboot" button.
Issue 1.1 April 2006
Figure 80: Reboot Confirmation Pop Up
Figure 81: Confirm Erase Configuration Pop Up
Page 114