9.2
Reset IP & Ethernet Configuration
To reset IP & Ethernet configuration back to factory defaults the user should press the "Reset
IP & Ethernet Configuration back to factory defaults" button on the "Recovery Options" page
(Figure 74). The user will now be presented with a pop up box asking them to confirm the
action (Figure 78).
On confirmation the following page will be displayed (Figure 79). The user should now reboot
the unit by pressing the "Reboot" button.
The user will now be presented with a pop up box asking them to confirm the action
Issue 1.1 April 2006
Figure 78: Confirm Reset to Factory Default Pop Up
Figure 79: IP and Ethernet Erased Successfully page
(Figure 80).
Page 113