Figure 23: System Configuration - Motorola Canopy 300 Mbps Backhaul User Manual

The save and restore submenu allows the system administrator to backup and restore
150/300 Mbps Backhaul configuration. It is recommended after a unit has been successfully
installed that a copy of the active configuration is taken and archived by the system
administrator.
8.3.1.1 General Configuration Page
The general configuration page ( Figure 23 ) is used by the system administrator to configure
the Canopy 150/300 Mb Backhauls high level administrative (descriptive) attributes and high
level wireless configuration.
Whilst the majority of the system configuration is entered during installation and should never
require changing, this page offers the system administrator the ability to change the basic
system parameters for both the wireless and Ethernet components.
Link Name User defined identity for the unit (max 63 characters).
Link Location Can be used as a generic scratch pad to describe the location of the
equipment.
Max Receive Modulation Mode This is the maximum mode the unit will use as its adaptive
modulation. The modulation modes available are specified in section 11.1 "System
Specifications ".
By default the Max Receive Modulation Mode is the highest mode available.
For minimum error rates on TDM links the user should set the maximum modulation mode to
64QAM 0.75 at both ends of the link.
Ethernet Capped Max Wireless Speed When enabled this option will cap the wireless
speed to a mode that the connected Ethernet connection can sustain.
Issue 1.1 April 2006
Figure 23: System Configuration Page
Page 58