Headlight Leveling Device System; Hazard Warning System; Right-Hand Drive Type; Left-Hand Drive Type - Hyundai Accent 2010 Owner's Manual

1
FEATURES OF YOUR HYUNDAI
HEADLIGHT LEVELING DE-
82
VICE SYSTEM
B340G01S-GAT
(If Installed)

Left-hand Drive type

B340G01MC

Right-hand Drive type

B340G01MC-R
To adjust the headlight beam level ac-
cording to the number of the passen-
gers and the loading weight in the lug-
gage area, turn the beam leveling switch.
The higher the number of the switch
position, the lower the headlight beam
level. Always keep the headlight beam
at the proper leveling position, or head-
lights may dazzle other road users.
Listed below are the examples of proper
switch settings. For loading conditions
other than those listed below, adjust the
switch position so that the beam level
may be the nearest as the condition
obtained according to the list.
Switch
Loading condition
position
Driver only 0
Driver + front passenger 0
Full passengers (including
1
driver)
Full passengers (including
driver) + full trunk loading 2
(or light trailer loading)
Driver + full trunk loading
3
(or maximum trailer loading)
HAZARD WARNING
SYSTEM
B370A01A-AAT
OMC025067
The hazard warning system should be
used whenever you find it necessary to
stop the car in a hazardous location.
When you must make such an emer-
gency stop, always pull off the road as
far as possible.
The hazard warning lights are turned on
by pushing in the hazard switch. This
causes all turn signal lights to blink.
The hazard warning lights will operate
even though the key is not in the igni-
tion.
To turn the hazard warning lights off,
push the switch a second time.