Using the Numeric Keys
1
Press [Process/Layout]
2
Press [No. Key Entry].
IMPORTANT
• Before performing the next step, you must manually measure the size and position of the area
that you want to designate on the original.
• When you measure the XY values, always start measuring from the image out to the right side
edge of the original, and up to the top of the original. These measurements tell the machine the
desired framed area's size and position.
3
Press [X1], [X2], [Y1], and [Y2]
the respective measurements.
[X1]: The distance of the area's right border to the original's right edge.
[X2]: The distance of the area's left border to the original's right edge.
[Y1]: The distance of the area's top border to the original's top edge.
[Y2]: The distance of the area's bottom border to the original's top edge.
You can designate up to four areas.
[Area Designation].
use
-
(numeric keys) to specify
Process/Layout Settings
7
7-71