1
1-26
Reserved Copying
If the following screen is displayed, adjust the width of the slide guides to match the paper size
stored in Stack Bypass Standard Settings, or set Stack Bypass Standard Settings to 'Off' in
Common Settings (from the Additional Functions screen). (See Chapter 4, "Customizing
Settings," in the Reference Guide.)
IMPORTANT
Set the paper size to the same size as the paper loaded in the stack bypass.
If you want to select a standard paper size:
Select the desired paper size
NOTE
To select an inch paper size, press [Inch-size].
Select the desired paper type
If you are copying onto the back side of a previously printed sheet, press [2nd Side of
2-Sided Page].
If you want to select a nonstandard paper size:
Press [Irreg. Size].
Press [X] (horizontal axis)
Press [Y] (vertical axis)
Press [OK].
You can also press a size key in which a paper size is registered ([S1] to [S5]), instead of
entering a value.
press [Next].
press [OK].
enter a value.
enter a value.