Turning On The Power - Roland Camm-1 CX-24/12 User Manual

4-3 Turning on the Power

Do not place the hands or anything
else on the platen when switching
on the power.
Doing so may result in injury.
(The cutting carriage moves simultaneously
when the power is switched on.)
Turn on the CX-24/12.
Putting the Machine in the Setup State
Use the control panel to put the CX-24/12 in the setup state (the state for receiving data).
For the CX-24:
Turn the dial.
1
When the display shows the type of load material,
press the [ENTER] key.
The cutting carriage starts to move.
SELECT | ROLL
ROLL: Roll material
EDGE: When performing cutting from the
front edge of the material
PIECE: Flat material such as standard-
size and piece material
21
4 Basic Operation