Roland Camm-1 CX-24/12 User Manual page 40

8 About the Blades and Materials
About the Cutting Area
The cutting area along the horizontal plane (the direction in which the tool carriage moves) is determined by the position of the pinch
rollers. The workable area spans the length between the two rollers, minus a margin of about 1 mm (about 0.04 in.) on both sides.
If you selected [PIECE] on the CX-24, then when the length of the material is 1,600 mm (63 in.) or more, the CX-24 determines it to be
roll material, and sets the length at 24,998 mm (984-1/8 in.).
Cutting Area
Material
About 1 mm
Pinch roller (Left)
(about 0.04in.)
Initial cutting coordi-
nate origin point (0,0)
When loading flat material
When you're using flat material, material that is at least 70 mm (2-13/16 in.) longer than the vertical size of the cutting data is required.
This is the length required for the pinch rollers to feed out the material to the front and rear. Refer to the figure below and ensure margins
at the front and rear of the material.
50 mm
(2 in.)
20 mm
(13/16 in.)
<CX-24>
Max.
584 mm (23 in.)
Pinch roller (Right)
Pinch roller
40
<CX-12>
Max.
280 mm (11in.)
Pinch roller (Right)