Self-Testing; Installing The Driver - Roland DXY_1350 User Manual

Self-testing

The arm and pen carriage move when the unit is switched on and while performing plotting --keep
hands and objects away at these times.
Self-test Mode
A self-test can be carried out to check whether the DXY is functioning correctly. When doing this, the plotter does
not have to be connected to the computer.
1. Load the pens included with the plotter in pen stocks 1
through 3. (See "Loading Pens.")
2. Turn on the power switch while holding down the
[ENTER] key.
3. The pen carriage moves to the upper right of the main
unit, and VIEW is enable (the VIEW LED lights up.)
4. Load an A3-size sheet of paper. (For instructions on
loading paper, see "Loading the Paper" on pages 8 and 9
for the DXY-1350A or on page 9 for the DXY-1150A.)
5. Press the [VIEW] key to disable VIEW.
6. The DXY then plots the self-test pattern.
When the pen is returned to the pen stock and the
carriage moves to the upper right of the main unit, the
self-test is finished.
Installing the
DRIVER
The DXY-1350A/1150A comes with drivers for Windows 3.1 and Windows 95. Be sure to install the correct driver
for your operating system.
About Installation
Be sure to read the notes on how to install the driver in the file Readme.doc on the Setup disk. In addition to an
explanation of installation and setup methods, this file contains the latest information about the driver, the operating
environment, and other important matters. You can view this file with a text editor such as Notepad.
The self-test plot is slightly larger than A4 size, so be
sure to use A3-size paper.
13