Bus Ft (Bus Format) - Omega DP41-S User Manual

9
Meter Function Menus

9.2.22 BUS FT (Bus Format)

Bus format is to select:
• whether or not to include check sum with reading [BUS.1]
• whether or not to include line feeds [BUS.2]
• whether or not to have the meter respond in echo mode [BUS.3]
• multipoint or point-to-point mode [BUS.4]
• (if in point-to-point mode) select whether to communicate continuously or
on command [BUS.5]
• whether a message character is used in handshake or continuous mode
[BUS.6]
• whether or not you have installed the RS-485 board [BUS.7]
• whether or not to enable the external print command at P2-11.
MENU
BUTTON
MAIN MENU
"BUS FT":
9-30
MIN/MAX/MENU *
BUTTON
SUB MENU
"BUS.1=0"
"BUS.1=1"
"BUS.2=0"
"BUS.2=1"
"BUS.3=0"
"BUS.3=1"
"BUS.4=0"
"BUS.4=1"
"BUS.5=0"
"BUS.5=1"
"BUS.6=0"
"BUS.6=1"
"BUS.7=0"
"BUS.7=1"
"BUS.8=0"
"BUS.8=1"
DESCRIPTION
BUS FORMAT
Check sum with reading:
Excluded
Included
Line feed following all <CR>'s:
Excluded
Included
Response from the meter (echo):
No
Yes
Point to Point mode or Multipoint mode:
Pt-Pt
Multi-Pt
Point-to-Point mode only:
Continuous
On Command
Handshake if continuous mode:
Message
Character
RS-485 Board installed:
Not installed
Installed
Print Command at P2-11:
Disabled
Enabled