Table of Contents
Advertisement
10.10 "OUT.CNF": CONTROL FLASHING OF THE DISPLAY
You may wish to bring abnormal conditions to immediate attention by
causing the display to flash.
Press the 'MIN' button to see "OUT.6".
Press the 'MAX' button to select "0", "1", "2", "3", "4", or "5".
"OUT.6=0" disables display flashing.
"OUT.6=1" flashes the display if SP1 is active.
"OUT.6=2" flashes the display if SP2 is active.
"OUT.6=3" flashes the display if SP3 is active.
"OUT.6=4" flashes the display if SP4 is active.
"OUT.6=5" flashes the display if any SP is active.
Save your choice or changes by pressing the 'MENU' button and the meter
will momentarily display "STORED", then "RUN" and proceed with normal
operation ( go into run mode).
10.11 ENTERING SETPOINT LEVELS (IN RUN MODE)
When you have completed selecting the setpoint(s) (and other features), the
last press of the 'MENU' button stores any changes and the meter will
automatically return to the run mode (the display will momentarily display
"RESET2"). The stored values are placed into operation, and the meter
proceeds with normal measurements.
Now you can view and reset all four setpoint levels.
1. Press the 'SETPTS' button. The meter now starts its setpoint display
cycle; every 15 seconds, the display flashes the SP number, and then
displays the value of that setpoint, with a flashing left-hand digit.
2. You can restart the time-out of any of these display intervals by pressing
the 'MIN' button (to shift the flashing [alterable] digit position), or by
pressing the 'MAX' button (to increment the value of that digit).
3. When you change the value of any setpoint and then decide to revert to
the original value instead, just press the 'RESET' button or allow the
display to return to "RUN" at the end of its cycle. The meter does not
store a new value for the setpoint in either case.
4. To save a newly-entered setpoint value, press the 'SETPTS' button
again.
5. You may return to viewing the measurements by pressing the 'RESET'
button or repeatedly pressing the 'SETPTS' button (or by letting the
meter complete its setpoint display cycle).
Setpoints/Alarms
10
10-9
Advertisement
Table of Contents
