Troubleshooting (Basic) - Panasonic FZ-G1 Series Operating Instructions Manual

Troubleshooting (Basic)

Follow the instructions below when a problem has occurred. There is also an advanced trouble-
shooting guide in the "Reference Manual". For a software problem, refer to the software's instruc-
tion manual. If the problem persists, contact Panasonic Technical Support (
can also check the computer's status in the PC Information Viewer
( Reference Manual "Troubleshooting (Advanced)").
Starting Up
Cannot start up.
The power indicator or
battery indicator is not
lit.
<Only for model with
(SSD)>
The power is turned on
but "Warming up the
system" appears.
Cannot turn on the com-
puter.
The computer does not
resume from sleep.
(The battery indicator
blinks green and orange
alternately.)
You have forgotten the
password.
"Remove disks or other
media. Press any key to
restart" or a similar mes-
sage appears.
Connect the AC adaptor.
Insert a fully charged battery.
If a device is connected to the USB port, disconnect the device, or
If If a If a device is connected to the ExpressCard slot, disconnect the
me menu o menu of the Setup Utility.
T T urn off the Turn off the concealed mode ( urn off th
ity"). it ity").
should be set to should be set to hould be set to
The computer is war The computer is warmi The computer is warming up before start up. Wait for the computer to
start up (the maximu start up (the maximum wa start up (the maximum waiting time will be displayed on the screen).
If, "Cannot warm up the syst If, "Cannot warm up the system" is displayed, the computer failed to not warm up
warm up and does not start. In this case, turn off the computer, leave warm up and does not start. In up and does not start. In
it in an environment of 5 it in an environment of 5 n environment of 5
hour, and then turn on the power again. our, and then turn on the power aga , and then turn on the powe
Leave it in an environment of 5 it in an environment it in an environment of 5
about an hour, then turn on the power again. hour, then turn on the power again hour, then turn on the power again
Support ( page 50).
If you have a password reset disk, you can reset the administrator
password. Set the disk and enter any wrong password, then follow
the on-screen instructions and set a new password.
If you do not have a password reset disk, install (
set up Windows, and then set a new password.
If a device is connected to the USB port, disconnect the device, or
ory failure. Contact Panasonic Technical Support (
Reference Manual
°C °C °C °F °F
{41 {41 {41 } or higher temperature for about an
°C °C °F °F
of {41 {41 } or higher temperature for
k, you can reset the administr eset the administr
ny wrong password, then ng pass
new password. w passw
k, ins k, install (
word.
page 50). You
-
"Setup Util-
pag page 30) and
-
-
page 50).
35