Panasonic FZ-G1 Series Operating Instructions Manual page 11

For U.S.A.
Federal Communications Commission
Radio Frequency Interference Statement
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful in-
terference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed rgy and rgy and
and used in accordance with the instructions, dance with t dance with t
may cause harmful interference to radio com- mful interference t mful interference
munications. However, there is no guarantee However, there is no g However, there is n
that interference will not occur in a particular erence will not occur in erence will not occur in a pa
installation. If this equipment does cause on. If this equipment does cause on. If this equipment does cause
harmful interference to radio or television re- nterference to radio or television r nterference to radio or television
ception, which can be determined by turning ich can be determined by turning ich can be determined by turning
the equipment off and on, the user is encour- t off and on, the user is encour- t off and on, the user is encour-
aged to try to correct the interference by one rrect the interference by one ect the interference by one
Reorient or relocate the receiving antenna. te the re
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
Consult the Panasonic Service Center or
an experienced radio/TV technician for
help.
Warning
To assure continued compliance, use only
shielded interface cables when connecting to
a computer or peripheral. Also, any changes
the party responsible for compliance could
void the user's authority to operate this equip-
ment.
This equipment is provided with PC Card
slot that could be used with wireless trans-
mended when they become available.
Other third-party wireless transmitters
have not been RF exposure evaluated for
use with this computer and may not com-
ply with FCC RF exposure requirements.
<Only for model with wireless LAN/wireless
WAN/Bluetooth>
This equipment complies with FCC radia-
tion exposure limits set forth for an uncon-
trolled environment.
This equipment may not be co-located or
operated with any other antenna or trans-
mitter.
us use
he receiving antenna. ceiving antenna.
tion between the tion between the
r
to an outlet on outle
o which the hich
Center or Center or
n f n for
-
This device meets the government's re-
quirements for exposure to radio waves.
This device is designed and manufactured
not to exceed the emission limits for expo-
sure to radio frequency (RF) energy set by
the Federal Communications Commission
of the U.S. Government.
The exposure standard for wireless device
employs a unit of measurement known as
SAR limit set by the FCC is
1.6 W/kg.
* Tests for SAR are conducted using stan-
dard operating positions accepted by the
FCC with the device transmitting at its
frequency bands.
Although the SAR is determined at the
SAR level of the device while operating
can be well below the maximum value.
This is because the device is designed
to to operate at multiple power levels so as
to u to use only the poser required to reach to u
the the ne the network. In general, the closer you
are are to a are to a wireless base station antenna,
th the lower th the lower the power output.
<Only for model with wireless LAN> <Only for model w Only for model w
This product is restr This product is restri This product is restricted to indoor use due
to its operation in the 5 to its operation in the 5.15 to 5.25 to its operation in the 5
quency range. FCC requires this product to quency range. FCC requ quency range. FCC requ
be used indoors for the frequency range 5.15 be used indoors for the fre be used indoors for the freq
GHz GHz GHz
to 5.25 to 5.25 5.25 to reduce the po to reduce the potential for harm- to reduce the pot
ful interference to co-channel M ful interference to co-channel Mobile Satellite ul interference to co-channel M
systems. High power radars are al systems. High power radars are allocated systems. High power radars are a
as primary users of the 5.25 to 5.35 primary users of the 5.25 to 5.35
GHz GHz
and 5.65 to 5.85 .65 to 5.85
stations can cause interference with and/or can cause interference with and
damage this product. his product.
This device complies with Part 15 of the FCC mplies with Part 15 plies wi
Rules. Operation is subject to the following is su is subject to th
(1) This device may not cause harmful inter-
ference, and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
Panasonic Corporation of North America
Two Riverfront Plaza
Newark, NJ 07102
GHz
fre-
G GHz
to 5.35
bands. These rad bands. These radar ds. These ra
erence with and
25-M-W-1
t cau
6-M-1
11