Panasonic FZ-G1 Series Operating Instructions Manual page 25

When the battery indicator does not light on
The battery indicator may not light on even if the AC adaptor and the battery pack are correctly
connected to the computer, due to the following reasons.
The AC adaptor's protection function may be working. In this case, pull out the AC cord and
wait for more than 1 minute before reconnecting the AC cord.
When the battery is fully charged and the computer is not operating (i.e., it is turned off or in
sleep mode), the power supply from the AC adaptor stops and power consumption is inhibited
(except when the Wake Up from LAN or the Power On by LAN function is enabled). In this
case, the indicator will light green upon connecting the AC adaptor, but only for a moment.
When using peripheral devices
Follow these instructions and the Reference Manual to avoid any damage to the devices. Care- uctions and uctions and
fully read the instruction manuals of the peripheral devices. struction manua struction manuals
Connect to the connectors in the correct direction. ct to the connectors in ct to the connectors in the c
If it is hard to insert, do not try forcibly but check the connector's shape, direction, alignment of s hard to insert, do not try forcibly s hard to insert, do not try forcibly
pins, etc. tc. tc.
If screws are included, fasten them securely. are included, fa ten them securel are included, fas
Remove the cables when you carry the computer. Do not pull the cables forcibly. cables w cables when
Preventing your computer from unauthorized use via wireless LAN/Bluetooth/Wireless r computer from unauthorized u
WAN
<Only for model with wireless LAN/Bluetooth/Wireless WAN>
Before using wireless LAN/Bluetooth/Wireless WAN, make the appropriate security settings
such as data encryption.
Battery Recalibration
The battery recalibration may take a long time due to the large battery capacity. This is not a
malfunction.
<When performing "Battery Recalibration" after shutting down Windows>
When performing "Battery Recalibration" without shutting down Windows, it may take more time to
charge / discharge.
Sensors
This computer is equipped with four sensors (acceleration sensor, gyro sensor, magnetic sensor,
ambient light sensor), and you can use these sensors with any software that is compatible.
As the accuracy of each sensor output is dependent on the operating environment and other con-
ditions, the results should only be used as a reference.
The acceleration sensor, gyro sensor, and magnetic sensor are located at the bottom left of the
LCD. The detection results of each sensor may vary depending on how you are holding the com-
puter, the application software you are using, and other factors.
pher pher
them securel
you carry the comp you carry the compu
mputer from unauthori
ess LAN/Bluetooth/Wireless WAN Bluetooth/Wireless WAN
N/Bluetooth/Wireless WAN, make t tooth/Wireless WAN, mak
long time due to the large battery due to the large battery
after shutting down Windows> er shutting down Windows>
down Windows, it may take more ti may take more ti
o s o sensor, ma
hat is c
on
25