Panasonic FZ-G1 Series Operating Instructions Manual page 37

Starting Up
Cannot resume.
Other startup problems. blems.
Entering Password
Even after entering the
password, password in-
put screen is displayed
again.
One of the following operations may have been carried out. Press the
power switch to turn on the computer. Data not saved will be lost.
In sleep mode, the AC adaptor or battery pack was disconnected, or
a peripheral was connected or disconnected.
The power switch was pressed for four seconds or longer to forcibly
turn off the computer.
An error may occur when the computer automatically enters the sleep
or hibernation mode while the screensaver is active. In this case, turn
off the screensaver or change the pattern of the screensaver.
Start the Setup Utility (
tu tu turn the Setup Utility settings (excluding the passwords) to the default
va values. Start the Setup Utility and make the settings again. value
Remov Remove all peripheral devices. Re
Ch Check to Check to see if there was a disk error.
A A Remove A Remove all peripheral devices including an external display. ove
B B
Perform either Perform either of the following procedures. Perform either
Touch and hold Touch and hol Touch and hold
screen. screen. scr
Flick from the middle Flick from the middle of the Start screen to the top. Flick from the m
Touch Touch uch
C C
D Touch and hold Touch and hold Touch and hold
E
A standard user needs to enter an administrator password. ndard user needs to enter an admin
F Follow the on-screen instructions. e on-screen instructions.
Connect the external keyboard and start the computer in Safe Mode, nal keyboard and start the compute
*1
appears at startup, press and hold
Options Menu is displayed. Select the Safe Mode and press
*1
boot screen disappears. As soon as you enter the password and press
Enter , press and hold F8 .
<Only if the external keyboard is connected>
The computer may be in ten-key mode.
If the NumLk indicator
key mode, and then input.
The computer may be in Caps Lock mode.
If the Caps Lock indicator
Caps Lock mode, and then input.
Reference Manual "Setup Utility") to re-
at the bottom left corner of the Desktop
er needs to enter an admi
en instructions.
al keyboard and start the compute
F8 8 until the Windows F8 until the Windows Advanced
ess and hold ss an until the Windows
. Select the Safe Mode and press
as you enter the password and
NumLk to disable the ten-
lights, press
lights, press
E Enter .
press
the password and
Caps Lock to disable the
37