Panasonic FZ-G1 Series Operating Instructions Manual page 31

4 <Only for model with TPM> Clear TPM.
A Perform either of the following procedures.
Touch and hold
Flick from the middle of the Start screen to the top.
B
C
puter" screen.
D
The computer will restart.
E
F
Hard disk (Flash memory) recovery Flash memory Flash memory)
Preparation
Remove all peripherals Remove all peripherals. Remove all peripherals.
Connect the AC adaptor and d Connect the AC adaptor and do not remove it until installation is complete. Connect the AC adaptor and d
You can reinstall the OS that was pre-installed at the time of purchase (Windows 8.1 or Windows 7). reinstall the OS that was pre-install reinstall the OS that was pre-install
If reinstallation using the metho If reinstallation using the metho If reinstallation using the method described in "Remove everything and reinstall
Windows" above is not successful, follow the steps below. ve is not successful, follow the ste ve is not successful, follow the ste
1 Start the Setup Utility. Setup Utility.
A Display "Charm", and touch
B
C
displayed.
left of the screen.
If the password is requested, enter the Supervisor Password.
2 Write down all of the contents of the Setup Utility and touch [Exit] and
double-touch [Load Default Values].
3 Check the [UEFI Boot] setting of the Setup Utility.
4 Touch [Exit] and double-touch [Save Values and Reboot].
Computer will restart.
5 Touch top left of the screen while [Panasonic] boot screen is dis-
played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
6 Touch [Exit] and double-touch [Recovery Partition].
at the bottom left corner of the Desktop screen.
Utility.
m", and touch m", and touch
e Supervisor Password. Supervisor Passw
the Setup Utility and touch the Setup Utility and touch
up Utility.
F12 .
ouching top
Reb Reboot].
31