M.2 Ssd Enablement Kit; M.2 Ssd Enablement Assembly - HP ProLiant ML30 Gen9 Maintenance And Service Manual

Remove the drive from the drive carrier.
7.
To replace the component, reverse the removal procedure.

M.2 SSD enablement kit

M.2 SSD enablement assembly

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power
input modules, and the internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
3.
Remove the access panel
4.
If installed, remove the PCI air baffle
5.
Remove the system air baffle.
6.
("Removing the access
("Air baffle" on page 28).
panel" on page 26).
Removal and replacement procedures 36