M.2 Ssd Module - HP ProLiant ML30 Gen9 Maintenance And Service Manual

Disconnect the SATA cables from the enablement board. Disconnect the other end of the SATA
7.
cables from the system board.
Remove the M.2 SSD enablement board.
8.
To replace the component, reverse the removal procedure.

M.2 SSD module

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power
input modules, and the internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
Before you perform this procedure, make sure that you have a No. 1 Phillips screwdriver available.
To remove the component:
Removal and replacement procedures 37