Processor - HP ProLiant ML30 Gen9 Maintenance And Service Manual

Finish the installation by completely tightening the screws in the same sequence.
c.
Install the air baffle.
4.
Install the access panel.
5.
Return the server to an upright position.
6.
Lock the tower bezel.
7.
Connect each power cord to the server.
8.
Connect each power cord to the power source.
9.
Press the Power On/Standby button.
10.
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.

Processor

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Remove all power:
1.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the bezel
2.
Place the server on its side with the access panel facing up.
3.
("Unlock and remove the bezel" on page 26).
Removal and replacement procedures 47