Scanning Part Of An Original - Ricoh en5100wd Operating Instructions Manual

Scan settings on the custom size setting screen
1. Original Size (X1 and Y1)
Specify the length and width of the custom size original.
Enter the actual width and length in [X1] and [Y1], respectively, and then press the [ ] key.
2. Start Position (X2 and Y2)
Set Start Position to 0 mm (0 in).
Enter "0" in both [X2] and [Y2], and then press the [ ] key.
3. Scan Area (X3 and Y3)
Specify the same values as Original Size (X1, Y1).
Enter the same values in [X3] and [Y3] as Original Size (X1 and Y1 respectively), and then press the [ ] key.

Scanning Part of an Original

This section explains how to specify a custom size for scanning part of an original.
To scan part of an original, measure Original Size (X1 and Y1), Start Position (X2 and Y2), and Scan
Area (X3 and Y3) on the surface of the original, and then enter those values in the same order on the
custom size setting screen.
To display the custom size setting screen, on the initial scanner screen, press [Scan Settings] > [Scan
Size] > [Custom Size].
Measuring methods differ depending on the original orientation. For details about how to measure
Original Size (X1 and Y1), Start Position (X2 and Y2), and Scan Area (X3 and Y3) correctly, see "How
to measure sizes".
Enter the sizes while referring to "Scan settings on the custom size setting screen".
Scanning Custom Size Originals
BLT010S
133