HP 6600 Command Reference Manual page 66

Current VCs: 0 (0 on main interface)
ATM over E1, Scramble enabled, frame-format crc4-adm
code hdb3, clock slave,Cable-length long, loopback not set
Cable type: 75 ohm non-balanced
Line Alarm: LOS LOF
Line Error: 0 FERR, 0 LCV, 0 CERR, 0 FEBE
Last 0 seconds input
Last 0 seconds output rate 0.00 bytes/sec, 0.00 packets/sec
Input : 0 packets, 0 bytes, 0 buffers
0 errors, 0 crcs, 0 lens, 0 giants,
0 pads, 0 aborts, 0 timeouts
0 overflows, 0 overruns,0 no buffer
Output: 0 packets, 0 bytes, 0 buffers
0 errors, 0 overflows, 0 underruns
# Display brief information about interface ATM 5/1/0.
<Sysname> display interface atm 5/1/0 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Atm5/1/0
# Display brief information about ATM interfaces in the DOWN state.
<Sysname> display interface atm brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
Atm5/1/0
Table 13 Command output
Field
Atm5/1/0 current state
AAL enabled: AAL5, Maximum
VCs: 128
ATM over E1, Scramble
enabled, frame-format crc4-adm
code hdb3, clock
slave,Cable-length long,
loopback not set
rate 0.00 bytes/sec, 0.00 packets/sec
Link Protocol Main IP
UP UP
Link Cause
DOWN Not connected
Description
State of the ATM interface:
•
DOWN(Administratively)—The ATM interface was shut down with the
shutdown command, and is administratively down.
•
DOWN—The ATM interface is physically down (possibly because no
physical link is present or the link has failed).
•
UP—The ATM interface is both administratively and physically up.
•
ATM adaptation layer (AAL) type: AAL5.
•
Maximum number of virtual circuits: 128.
•
ATM interface type: ATM over E1.
•
Scrambling is enabled.
•
Framing format: crc4-adm.
•
Line coding format: hdb3.
•
Clock mode: slave.
•
Cable mode: long.
•
Loopback is not enabled.
57
Description
--