Feac - HP 6600 Command Reference Manual

Field
Line loop back activate code using
inband signal last sent
BERT state
Test pattern
Status
Sync Detected
Time
Time past
Bit errors (since test started)
Bits received (since test started)
Bit errors (since latest sync)
Bits received (since latest sync)

feac

Use feac to enable FEAC channel signal detection and sending on the CT3 interface.
Use undo feac to remove the current FEAC settings.
Syntax
feac { detect | generate { ds3-los | ds3-ais | ds3-oof | ds3-idle | ds3-eqptfail | loopback { ds3-line |
ds3-payload } } }
undo feac { detect | generate { ds3-los | ds3-ais | ds3-oof | ds3-idle | ds3-eqptfail | loopback
{ ds3-line | ds3-payload } } }
Default
Periodical FEAC channel signal detection is enabled.
Default
FEAC signal sending is disabled.
Default
Loopback code sending is disabled.
Views
CT3 interface view
Default command level
2: System level
Parameters
detect: Enables periodical far end and control signal (FEAC) channel signal detection. generate: Sends
FEAC signals. Specify ds3-los for DS3 LOS, ds3-ais for DS3 AIS, ds3-oof for DS3 out of frame (OOF),
ds3-idle for DS3 idle, and ds3-eqptfail for DS3 equipment failure. loopback: Sends loopback code for
activating far-end line loopback with the ds3-line keyword or payload loopback with the ds3-payload
keyword.
Description
The loopback code sent last time is in-band LLB activation request
code.
BERT test state: running, complete, or stopped (not completed).
Test pattern in use, 2^11 in this sample output; synchronization
state, and the number of detected synchronizations.
Duration of the BERT test and time that has elapsed.
Number of bit errors received since start of the BERT test.
Number of bits received since start of the BERT test.
Number of bit errors received since last synchronization.
Number of bits received since last synchronization.
170