Group-Member; Jumboframe Enable - HP 6600 Command Reference Manual

Examples
# Set the statistics polling interval to 100 seconds for all interfaces.
<Sysname> system-view
[Sysname] flow-interval 100

group-member

Use group-member to assign Ethernet interfaces to a port group.
Use undo group-member to remove Ethernet interfaces from the port group.
Syntax
group-member interface-list
undo group-member interface-list
Default
A port group does not contain any member ports.
Views
Port group view
Default command level
2: System level
Parameters
interface-list: Specifies an Ethernet interface list, in the form of interface-type interface-number [ to
interface-type interface-number ] &<1- 1 0>, where &<1- 1 0> indicates that you can specify up to 10
interfaces or interface ranges.
Usage guidelines
If you use the group-member interface-type interface-start-number to interface-type interface-end-number
command to add multiple ports in batch to the specified port group, make sure all these ports are of the
same type and on the same interface card, and the interface-end-number argument must be greater than
the interface-start-number argument.
Examples
# Assign GigabitEthernet 4/0/1 to the port group named group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member gigabitethernet 4/0/1

jumboframe enable

Use the jumboframe enable command to allow jumbo frames within the specified length to pass through
an Ethernet interface, a group of Ethernet interfaces, or all Ethernet interfaces.
Use the undo jumboframe enable command to prevent jumbo frames from passing through an Ethernet
interface, a group of Ethernet interfaces, or all Ethernet interfaces.
Syntax
jumboframe enable [ value ]
36