Itf - HP 6600 Command Reference Manual

Syntax
invert transmit-clock
undo invert transmit-clock
Default
Transmit-clock signal inversion is disabled on DTE-side synchronous serial interfaces.
Views
Serial interface view
Default command level
2: System level
Usage guidelines
Sometimes, you may need to invert the receive-clock signal on a DTE-side serial interface to eliminate the
half clock-period delay on the line. This command is necessary only for some special DCE devices. In
common applications, do not invert the clock.
Examples
# Invert the transmit-clock on DTE-side synchronous serial interface 1/0/0.
<Sysname> system-view
[Sysname] interface serial 1/0/0
[Sysname-Serial1/0/0] invert transmit-clock
Related commands
invert receive-clock
•
clock
•

itf

Use itf to set the number of interframe filling tags.
Syntax
itf number number
undo itf number
Default
The number of interframe filling tags is four.
Views
Synchronous serial interface view
Default command level
2: System level
Parameters
number number: Sets the number of interframe filling tags (an interframe filling tag is one byte in length).
The value ranges from 0 to 14 bytes.
Examples
# Set the number of interframe filling tags to five.
82