Basic Ct1 Interface Configuration Commands; Alarm (Ct1 Interface); Alarm-Threshold - HP 6600 Command Reference Manual

Basic CT1 interface configuration commands

alarm (CT1 interface)

Use alarm to enable RAI detection on the interface.
Use undo alarm to disable RAI detection on the interface.
Syntax
alarm detect rai
undo alarm detect rai
Default
RAI detection is enabled on an interface.
Views
CT1 interface view
Default command level
2: System level
Parameters
detect: Enables periodical detection on the interface.
rai: Remote Alarm Indication (RAI).
Usage guidelines
This command is applicable when the framing format used on the interface is ESF.
Examples
# Disable RAI detection on CT1 interface T1 2/0/0.
<Sysname> system-view
[Sysname] controller t1 2/0/0
[Sysname-T1 2/0/0] undo alarm detect rai

alarm-threshold

Use alarm-threshold to set LOS, AIS, or LFA alarm thresholds on the CT1 interface.
Use undo alarm-threshold to restore the default.
Syntax
alarm-threshold { ais { level-1 | level-2 } | lfa { level-1 | level-2 | level-3 | level-4 } | los { pulse-detection
| pulse-recovery } value }
undo alarm-threshold { ais | lfa | los { pulse-detection | pulse-recovery } }
Views
CT1 interface view
Default command level
2: System level
101