Reset Counters Controller T3; T1 Alarm - HP 6600 Command Reference Manual

[Sysname-T3 2/0/0] mdl data lic hello
# Send path messages on CT3 interface T3 2/0/0.
<Sysname> system-view
[Sysname] controller t3 2/0/0
[Sysname-T3 2/0/0] mdl generate path

reset counters controller t3

Use reset counters controller t3 to clear the controller counter of the specified CT3 interface.
Syntax
reset counters controller t3 interface-number
Views
User view
Default command level
2: System level
Parameters
interface-number: Interface number.
Usage guidelines
You can use the display controller t3 command to display the statistics collected by the controller
counters of CT3 interfaces.
The reset counters interface command clears the counters of all interfaces. To clear the controller counter
of individual CT3 interfaces, use the reset counters controller t3 command.
Examples
# Clear the controller counter of the CT3 interface E3 2/0/0.
<Sysname> reset counters controller t3 2/0/0

t1 alarm

Use t1 alarm to enable the specified T1 line on the CT3 interface to detect/send alarm signals.
Use undo t1 alarm to remove the alarm signal detection/sending setting.
Syntax
t1 line-number alarm { detect | generate { ais | rai } }
undo t1 line-number alarm { detect | generate { ais | rai } }
Default
Periodical alarm detection is enabled.
Default
Alarm signal sending is disabled.
Views
CT3 interface view
176