Cable (Ct1 Interface) - HP 6600 Command Reference Manual

Views
CT1 interface view
Default command level
2: System level
Parameters
pattern: Sets a bit error rate test (BERT) pattern, which could be 2^15 or 2^20.
2^15: Specifies the length of transmitted BERT pattern, in bits, as two to the fifteenth power.
2^20: Specifies the length of transmitted BERT pattern, in bits, as two to the twentieth power
time minutes: Sets the duration (in minutes) of a BERT test. The minutes argument ranges from 1 to 1,440.
unframed: Sets the test pattern to cover the overhead bits of the frame.
Usage guidelines
ITU O.151, ITU O.153, and ANSI T1.403- 1 999 define many BERT patterns, among which, the CT1
interface supports only 2^15 and 2^20.
When running a BERT test, the local end sends out a pattern, which is to be looped over somewhere on
the line and back to the local end. The local end then examines the received pattern for bit error rate to
help you identify the condition of the line. You must configure loopback to allow the transmitted pattern
to loop back from somewhere on the line, for example, from the far-end interface by placing the interface
in a far-end loopback.
You may view the state and result of the BERT test with the display controller t1 command.
Examples
# Run a 10-minute 2^20 BERT test on CT1 interface t1 2/0/0.
<Sysname> system-view
[Sysname] controller t1 2/0/0
[Sysname-T1 2/0/0] bert pattern 2^20 time 10

cable (CT1 interface)

Use cable to set the cable attenuation and length on the CT1 interface.
Use undo cable to restore the default.
Syntax
cable { long { 0db | -7.5db | -15db | -22.5db } | short { 133ft | 266ft | 399ft | 533ft | 655ft } }
undo cable
Default
The cable length is long 0db.
Views
CT1 interface view
Default command level
2: System level
103