Using (Ct3 Interface) - HP 6600 Command Reference Manual

[Sysname-T3 2/0/0] t1 1 unframed
Related commands
t1 channel-set

using (CT3 interface)

Use using to configure the operating mode of a CT3 interface.
Use undo using to restore the default.
Syntax
using { ct3 | t3 }
undo using
Default
The operating mode of a CT3 interface is channelized mode.
Views
CT3 interface view
Default command level
2: System level
Parameters
ct3: Sets the CT3 interface to operate in channelized mode.
t3: Sets the CT3 interface to operate in unchannelized mode.
Usage guidelines
You can configure T1 lines on CT3 interfaces operating in channelized mode only.
When a CT3 interface operates in unchannelized mode, the system automatically creates a serial
interface numbered serial number/0:0 for it. This interface operates at 44.736 Mbps and is logically
equivalent to a synchronous serial interface on which you can make other configurations.
Examples
# Configure interface T3 2/0/0 to operate in unchannelized mode.
<Sysname> system-view
[Sysname] controller t3 2/0/0
[Sysname-T3 2/0/0] using t3
186