Group-Member; Jumboframe Enable - HP MSR series Command Reference Manual

<Sysname> system-view
[Sysname] flow-interval 100

group-member

Use group-member to assign Ethernet interfaces to a port group.
Use undo group-member to remove Ethernet interfaces from the port group.
Syntax
group-member interface-list
undo group-member interface-list
Default
A port group does not contain any member ports.
Views
Port group view
Default command level
2: System level
Parameters
interface-list: Specifies an Ethernet interface list, in the form of interface-type interface-number [ to
interface-type interface-number ] &<1- 1 0>, where &<1- 1 0> indicates that you can specify up to 10
interfaces or interface ranges.
Usage guidelines
If you use the group-member interface-type interface-start-number to interface-type interface-end-number
command to add multiple ports in batch to the specified port group, make sure that all these ports are of
the same type and on the same interface card, and the interface-end-number argument must be greater
than the interface-start-number argument.
Examples
# Assign Ethernet 1/1 to the port group named group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member ethernet 1/1

jumboframe enable

Use jumboframe enable to allow jumbo frames within the specified length to pass through an Ethernet
interface or a group of Ethernet interfaces.
Use undo jumboframe enable to prevent jumbo frames from passing through an Ethernet interface or a
group of Ethernet interfaces.
Syntax
jumboframe enable [ value ]
undo jumboframe enable
Default
The router allows jumbo frames within a specified length to pass through Layer 2 Ethernet interfaces.
31