Completing The Table Plate For The Mg 56-3 Stand With Direct Drive - Dürkopp Adler 869 Operating Instructions Manual

3.6

Completing the table plate for the MG 56-3 stand with direct drive

7
5
Top view of table plate
6
(4x20) 2x
(5x25) 2x
7
(5x25) 2x 4
–
Turn over the table plate 5.
–
Screw on the drawer 1 together with its fixtures.
–
Screw on the motor control 2.
–
Screw on the power supply 3.
–
Screw on flap trays 7 using two wood screws per tray.
–
Screw on the knee switch 4 for the sewing-foot stroke.
–
Screw on the sewing light transformer 6 (optional equipment).
–
Screw on the cable duct 8.
–
Mount the electrical cable according to the instructions in
chapter 12.
3
(4x20) 2x 2
8
(3,5x17) 2x
Marking for stand
1
(3,5x17) 6x
GB
11