Completing The Table Plate - Dürkopp Adler 567 Operating Instructions Manual

7.4 Completing the table plate

The table plate belongs to the optional delivery scope.
To prepare the table plate yourself, please refer to the drawings in
the  Appendix.
Fig. 32: Completing the table plate
1
2
3
(1) - Upper section support
(2) - Recesses for the lower
(3) - Drawer
(4) - Oil pan
1. Screw the drawer (3) with the left-hand bracket to the underside
2. Screw the oil pan (4) under the machine recess.
3. Screw the cable duct (5) to the underside of the table plate.
4. Insert the thread reel holder (7) in the hole.
5. Fasten the thread reel holder (7) with nut and washer.
6. Screw the thread real holder and the unwinding bracket onto the
7. Insert the upper section support (1) in the hole.
8. Insert the lower hinge parts in the recesses (2) and tighten.
9. Insert the rubber corners in the corner protrusions (6).
50
hinge parts
of the table plate.
thread reel holder (7) in such a way that they are exactly opposite
each other.
7
40 mm
6
5
4
(5) - Cable duct
(6) - Corner protrusions for the
rubber corners
(7) - Thread reel holder
Operating manual 567 Version 01.0 - 01/2015
Set-up instructions