Changing The Hook-Thread Bobbin - Dürkopp Adler 869 Operating Instructions Manual

6.7 Changing the hook-thread bobbin

1
6
5
4
18
Caution: Risk of injury!
Turn off the main switch.
The hook-thread bobbin may only be changed with the machine
switched off.
Remove the empty bobbin
–
Slide the cover 1 sideways, raise up the flap 7 and remove the empty
bobbin 2.
Insert a full bobbin
–
Insert the bobbin 2 so that it moves in the opposite direction of the hook
when unwinding.
–
Pass the hook thread through the slit 3 and underneath the spring 4.
–
Pull the hook thread through the slit 6 and continue pulling until it stands
out about 3 cm.
–
Close the flap 7 and pull the hook thread through the thread guide 5 of
the flap.
2
7
2
3