6.6 Winding on the hook thread
5
4
3
2
1
–
Put the thread reel on the thread stand and lead the needle thread
through the unwinder arm.
–
Pull the thread through the thread guide 3, the tensioner 5 and the
thread guide 3.
–
Clamp the thread behind the blade 6 and tear it off.
–
Fit the bobbin 1 on the bobbin winder.
There is no need to wind the thread around the bobbin by hand.
–
Press the bobbin-winder lever 2 into the bobbin.
–
Sewing.
The bobbin-winder lever terminates the process as soon as the bobbin
is full.
The bobbin winder always stops in such a position that the blade 6 is in
the insertion position
(see right-hand illustration)
–
Remove the full bobbin 1, clamp the thread behind the blade 6 and tear
it off.
–
Fit empty bobbin on the bobbin winder for the next winding process and
press the bobbin-winder lever 2 into the bobbin.
Attention: Danger of breakage!
If the thread is not to be wound on during sewing, it is essential for
the sewing foot to be locked in the raised position and the
sewing-foot stroke set to the smallest value.
2
6
GB
17