Configuring with Web Based Management
5.4 The "System" menu
5.4.22.2
SFP diagnostics
On this page, you run independent error diagnostics for each individual SFP port. This test is
performed without needing to remove the cable, connect a cable tester or install a loopback
module at the other end.
Description
The page contains the following boxes:
● Port
Select the required port from the drop-down list.
● Refresh
Refreshes the display of the values of the set port. The result is shown in the table.
The values are shown in the following boxes:
● Name
Shows the name of the interface.
● Model
Shows the type of interface.
● Revision
Shows the hardware version of the SFP.
242
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12