Wan Ip Address; Isp Profile For Ppp - Planet GRT-101 User Manual

PLANET Technology Corp.

3.12.4 WAN IP address

Note: This sub-section is for routing mode operation with protocol of "Ethernet" and/or "IPoA" only. For PPP
connections, it is unnecessary to set the WAN port IP address and subnet mask.
To set the WAN 3 with IP address of 192.168.3.3 and subnet mask of
255.255.255.0, follow the following example:
admin# setup wan 3 address 192.168.3.3 255.255.255.0
To review the new configuration you have configured, type:
admin# setup wan 3 list
WAN Interface Parameters
Int. Link IP Address/
---- -------- ----------------------------- --------- ------ --- ----
WAN 1 Disable
WAN 2 Disable
WAN 3 Ethernet 192.168.3.3/ 255.255.255.0
WAN 4 Disable
WAN 5 Disable
WAN 6 Disable
WAN 7 Disable
WAN 8 Disable
To save the new WAN port configuration, enter:
admin# write

3.12.5 ISP profile for PPP

Note: This sub-section is for routing mode operation only.
If your local ISP uses protocols of "PPPoA" or "PPPoE" over the ATM VC, you
may need to setup the username and password information provided from
your local ISP. The maximum length of username and password for ISP
setting is limited to 51. The following command configures the ISP profile for
WAN 3 with username "pppoa3@isp.com", password "Fuyg47ds", and idle
timeout of 10 minutes:
Netmask VPI/ VCI Encap. QoS PCR
0/ 135 VC-Mux CBR 512
- - 58
GRT-101/401 User's Manual