Setup; Mode; Shdsl - Planet GRT-101 User Manual

PLANET Technology Corp.

3.8 Setup

All of the setup parameters are located in the subdirectories of setup. Move the
cursor " >> " to setup and press enter.
>> mode

shdsl

wan
bridge
route
lan
ip_share
dhcp
dns_proxy
hostname
default

3.8.1 Mode

The product can act as routing mode or bridging mode. The default setting is
routing mode. You can change the system operation mode by using mode
command. Move the cursor " >> " to mode and press enter.
---------------------------------------------------------------------
Command: setup mode <Route|Bridge>
Message: Please input the following information.
System operation mode (TAB select) <Route>: Route
---------------------------------------------------------------------
3.8.2 SHDSL
You can setup the SHDSL parameters by the command shdsl. Move the
cursor " >> " to shdsl and press enter.
>> mode
n*64
type
clear
margin
There are two types of SHDSL mode, STU-R and STU-C. STU-R means the
terminal of central office and STU-C customer premises equipment.
You can setup the data rate by the multiple of 64Kbps- n is from 0 to 32. If you
Switch system operation mode
Configure SHDSL parameters
Configure WAN interface profile
Configure transparent bridging
Configure routing parameters
Configure LAN interface profile
Configure NAT/PAT parameters
Configure DHCP parameters
Configure DNS proxy parameters
Configure local host name
Restore factory default setting
Configure SHDSL mode
Configure SHDSL data rate
Configure SHDSL annex type
Clear current CRC error count
Configure SHDSL SNR margin
GRT-101/401 User's Manual
- - 42