Planet GRT-101 User Manual page 61

PLANET Technology Corp.
VC when communicating across your local ISP network.
For bridging mode operation, you should select Ethernet over ATM (RFC 1483
bridged Ethernet) as the ATM protocol. For routing mode operation,
GRT-101/GRT-401 supports Ethernet over ATM (RFC 1483 bridged Ethernet),
IP over ATM (RFC 1483 routed IP/RFC 1577), PPP over ATM (RFC 2364),
and PPP over Ethernet (RFC 2516). The following example enables the ATM
VC WAN 3 with protocol of Ethernet over ATM:
admin# setup wan 3 protocol Ethernet
where the selectable parameters corresponding to the above ATM protocols
are "Ethernet", "IPoA", "PPPoA", and "PPPoE". To disable the pre-configured
ATM VC WAN 1, enter:
admin# setup wan 1 protocol Disable
The valid ranges for the VPI is from 0 to 255. For the VCI, it is between 0 and
65535.
The following example set the VPI/VCI = 0/135 for ATM VC WAN 3
admin# setup wan 3 vpi_vci 0 135
To change the encapsulation from default LLC to VC-Mux for ATM VC WAN 3
admin# setup wan 3 encap VC-Mux
To review the new configuration you have changed for WAN 3, type:
admin# setup wan 3 list
WAN Interface Parameters
Int. Link IP Address/
---- -------- ----------------------------- --------- ------ --- ----
WAN 1 Disable
WAN 2 Disable
WAN 3 Ethernet 192.168.3.1/ 255.255.255.0
WAN 4 Disable
WAN 5 Disable
WAN 6 Disable
WAN 7 Disable
WAN 8 Disable
To save the new WAN port configuration, enter:
admin# write
Netmask VPI/ VCI Encap. QoS PCR
0/ 135 VC-Mux UBR 2400
- - 56
GRT-101/401 User's Manual