Cash Drawer Control Selection - Protech Systems PA-6322 User Manual

2.6.5

Cash Drawer Control Selection

JP15: DRW1, DRW1-1, DRW1-2
DRW1 port is used by default. You can add a
second port via either of the methods below:
Method 1:
DRW1 includes two groups of GPIO pins.
The second group is normally unused but can be
enabled by the jumper. Set the pin header jumper
JP15 as 1-2 connected if necessary.
Method 2:
You can split DRW1 into two channels of
DRW1-1 & DRW1-2 using the Y-Cable (option).
JP15: Cash Drawer 2 Selection
SELECTION
DRW1-1 &
DRW1-2
DRW1-1 only
Step 3.
DRW1, DRW1-1, DRW1-2 shares the same power source.
(Default: 12V).
SIO Address
Cash drawer 1
Cash drawer 2
PA-6322 SERIES USER MANUAL
JUMPER SETTING
1-2
2-3
LDN 06, 0x91 bit 2
LDN 06, 0x91 bit 3
Chapter 2 System Configuration
JUMPER ILLUSTRATION
JP15
JP15
Page: 2-14