Installing Expansion Unit - Panasonic KX-TD1232E Installation Manual

2.4.6 Installing Expansion Unit

1. Loosen the two the screws on the cover
plate. Insert fingers into the slits to
remove the cover plate.
Slit
Note Any of the cover plates can be
removed, as needed.
2. Connect the cabinet cord to the
connector in the main unit firmly.
The following procedures can be used to install either Extension
Unit (KX-TD170), CO Line / ISDN S0 Line Unit (KX-TD180,
KX-TD280, KX-TD286, KX-TD290). There are two expansion
areas for KX-TD816 and three expansion areas for KX-TD1232.
System programming is required for unit location identification.
Default KX-TD816: bottom = 4-CO Line Unit,
KX-TD1232: bottom = 4-CO Line Unit,
Note The KX-TD1232 is illustrated as a main unit.
Slit
top = 8-Station Line Unit
middle and top = 8-Station Line Unit
3. Hook the cabinet to the main unit and
slide the cabinet to the left until it is
fixed.
4. Loosen the outside screw and slide the
cover to the right.
Outside screw
Installation 2-37