Pitney Bowes ADDRESSRIGHT DA300 Operator's Manual page 81

Appendix A • Control Panel Menus
1. Address Layout
(continued)
DA300 Printer Operator Guide
B. Distance to Bottom (Bottom Margin)
Use this option to set the distance from the top address
line to the bottom of the envelope. For #10 envelopes
this should be about two inches.
Press the + or – buttons to increase or decrease the
Distance to Bottom, (+ MORE or – LESS) defined in
inches or millimeters. The bottom margin is the distance
between the bottom edge of the material and first line of
the address. Minimum distance between the last line of
the address and the bottom edge of the material is 5/8
inches. If less than 5/8 inches, the lower right barcode
will not be printed. Press the Enter button to enable the
desired measurement.
C. Line Spacing
Press the + or – buttons to increase or decrease the
Line Spacing (i.e., 3, 4, 6, 8 lines/inch or Automatic),
defined in lines per inch. Automatic line pitch selection is
based on industry-standard definitions for line spacing
for each print pitch and style selected. The printer will
automatically select the correct setting for the font and
size of the characters being printed.
D. Orientation
The choices are Normal and Inverted. Select Normal for
most applications. This tells the printer that the bottom
edge of the material feeds first, with the right side run-
ning against the right side of the printer. The Inverted
option tells the printer that the top edge of the material
feeds first. Select this option if, for example, you need
to feed envelopes flap first.
E. Orientation Control
The choices are Automatic and Manual. For Automatic,
the software determines the orientation control of your
addresses. For Manual, the settings in the Control Menu
determines the orientation control of your addresses.
A-8