Pitney Bowes ADDRESSRIGHT DA300 Operator's Manual page 72

Other
Problems
(continued)
DA300 Printer Operator Guide
Problem Shuttle Jam
Reason: Envelope thickness lever is set too low for
material.
Solution: Open the back of the printer, and adjust
the media thickness lever (see page 3-13).
Reason: Lower rail shaft dirty.
Solution: Wipe lower rail shaft clean.
Problem Memory Card Error
Reason: The card was removed while the printer
was reading it.
Solution: Do not remove the card while the printer is
in use. If the card has been removed, insert
the card, turn the printer off, then turn the
printer on again.
Problem Out of Memory
Reason: The printer can run out of memory when
downloading fonts or graphics.
Solution: This generally means you're trying to use a
graphic (artwork) that's too big or you
have too many fonts or too large a font
size. If the out-of-memory message
appears, try reducing the size of your art
and limiting the number and size of your
fonts. Then shut the printer OFF, then ON
and retry.
Troubleshooting • 6
6-7